Table of Contents
Advertisement
8. FCC Statement
NOTICE:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications made to this equipment not expressly approved by ValenceTech Limited may void the FCC
authorization to operate this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Radiofrequency radiation exposure information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. Please see the RF
Exposure information. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device should be installed and operated with a minimum distance of 20cm between the antenna and all persons.
Label requirements:
Contains Transmitter Module FCC ID: ORP-IBT-07
Host use instruction:
The module must install and work with a speaker,
The speaker's manufacturer is ValenceTech Limited.
The Host mode name: IBT07 BLUETOOTH SPEAKER SYSTEM
The Host Brand Name: ValenceTech
The host is a fixed device and the antenna used with this host should be installed and operated with a minimum distance of 20cm
from all persons.
FCC RF Exposure Requirement
1.
At least 20cm separation distance between the antenna and the user's body must be maintained at all times.
And must not transmit simultaneously with any other antenna or transmitter, except in accordance with FCC multi transmitter
product procedures.
2.
To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation, the
maximum antenna gain including cable loss in a mobile-only exposure condition must not exceed 0dBi in the 2.4G band.
3.
A user manual with the end product must clearly indicate the operating requirements and conditions that must be observed to
ensure compliance with current FCC RF exposure guidelines.
Note: If this module is intended for use in a portable device, you are responsible for separate approval to satisfy the SAR
requirements of FCC Part 2.1093.
0.6.01
Bluetooth Module for Audio Application
8 / 12
iBT-07
2012-11-29
Advertisement
Table of Contents
