Valence Tech iBT-07 Manual page 10

iBT-07
Bluetooth Module for Audio Application
OEM RESPONSIBILITIES TO COMPLY WITH FCC REGULATIONS
The iBT-07 Module has been certified for integration into products only by OEM integrators under the following conditions:
This device is granted for use in Mobile only configurations in which the antennas used for this transmitter must be installed to
provide a separation distance of at least 20cm from all person and not be co-located with any other transmitters except in
accordance with FCC and Industry Canada multi-transmitter product procedures.
As long as the two conditions above are met, further transmitter testing will not be required. However, the OEM integrator is still
responsible for testing their end-product for any additional compliance requirements required with this module installed (for
example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions cannot be met (for certain configurations or co-location with
another transmitter), then the FCC and Industry Canada authorizations are no longer considered valid and the FCC ID
and IC Certification Number cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC and Industry
Canada authorization.
OEM LABELING REQUIREMENTS FOR END-PRODUCT
The iBT-07 module is labeled with its own FCC ID Certification Number. The FCC ID certification numbers are not visible when
the module is installed inside another device, as such the end device into which the module is installed must display a label
referring to the enclosed module. The final end product must be labeled in a visible area with the following:
"Contains Transmitter Module FCC ID: ORP-IBT-07"
or
"Contains FCC ID: ORP-IBT-07"
The OEM of the iBT-07 Module must only use the approved antenna(s) listed above, which have been certified with this module.
The device iBT-07 carries FCC authorization and is marked with the FCC ID Number. Whilst any device into which this
authorized module is installed will not normally be required to obtain FCC authorization, this does not preclude the possibility that
some other form of authorization or testing may be required for the finished device.
OEM END PRODUCT USER MANUAL STATEMENTS
The OEM integrator should not to provide information to the end user regarding how to install or remove this RF module or
change RF related parameters in the user manual of the end product.
If this module is intended for use in a portable device, you are responsible for separate approval to satisfy the SAR requirements
of FCC Part 2.1093.
The user manual for the end product must include the following information in a prominent location:
This device is granted for use in Mobile only configurations in which the antennas used for this transmitter must be installed to
provide a separation distance of at least 20cm from all person and not be co-located with any other transmitters except in
accordance with FCC and Industry Canada multi-transmitter product procedures.
The end product with an embedded FCC ID:ORP-IBT-07 Module may also need to pass the FCC Part 15 unintentional emission
testing requirements and be properly authorized per FCC Part 15.
The labeling instructions of finished products refer to following requirements:
A certified modular has the option to use a permanently affixed label, or an electronic label (see Electronic Labelling below). For
a permanently affixed label, the module must be labelled with an FCC ID - Section 2.926 (see Certification (labelling
requirements) above). The OEM manual must provide clear instructions explaining to the OEM the labelling requirements,options
and OEM user manual instructions that are required (see next paragraph).
0.6.01 10 / 12 2012-11-29