Figure 6: Webmin Overview; Figure 7: Webmin Kiosk Mode - Janz Tec emWEB-10WT Hardware And Software Manual

emWEB-10WT (Hardware and Software Manual) • Operating System and Drivers
On the first boot the system has to be configured for the kiosk mode. This includes to define a default
homepage which should be loaded after starting the operating system.
For configuring the kiosk mode, open the "Kiosk Configuration" page on the webmin service. Have a
look to Fehler! Verweisquelle konnte nicht gefunden werden.. After setting up the homepage, note
that the changes has to be committed to the filesystem. Choose the "reboot-commit now" button to
apply the configuration.
Once the kiosk mode is enabled and a default page is shown at the start up, there are following ways
to (re-)configure the emWEB-10WT.
1. GUI based modification
Apply a keyboard to the emWEB-10WT and press "Ctrl" + "Shift" + "T". This opens
a new browser tab and show the navigation bar. Open "http://127.0.0.1/"
2. Command line based modification
Apply a keyboard to the emWEB-10WT and press "Ctrl" + "Alt" + "F1" (Alternatively
open a SSH shell).
After pressing, a shell will appear and gives access with the specified credentials. For
modifying the homepage, edit the file "/etc/kiosk.conf"
Rev. 1.1

figure 6: Webmin overview

figure 7: webmin kiosk mode

5 - 17
© Janz Tec AG