Table of Contents
Advertisement
4 - 10
4
Installation
When opening the shipping package of the emWEB-10WT, the contents of the package should be
checked immediately.
The emWEB-10WT is delivered in a configured state, but the configurations can be adjusted by the
user as well. To adjust the emWEB-10WTs configuration.
The package also contains a terminal plug for the power connector. The emWEB-10WT needs a
power source in between 9 to 34V DC for operation.
The installation of this equipment is allowed for qualified service personnel, only.
Auxiliary existing rules for installation of electrical equipment must be attended to.
4.1
Dimensions and mounting information
The needed cut-out measures are given in figure 2. The overall front panel dimensions are denoted
with W and H. D is the depth of the case. The front has 8 mm thickness.
© Janz Tec AG
emWEB-10WT (Hardware and Software Manual) • Installation
H
W
figure 1: emWEB-10WT measures
W
H
288.0 mm
225.0 mm
table 1: emWEB-10WT dimensions
D
33.0 mm
D
Rev. 1.1
Advertisement
Table of Contents
