Samsung SW70W9 User Manual page 11

chilD-lock
funcTion
8
/
remaining Time,
Delay sTarT
9
Time, error
Display
soak buTTon
10
Delay sTarT
11
buTTon
lasT seTTing
12
waTer leVel
13
buTTon
waTer supply
14
buTTon
SW70W9XFP-02961E-01_EN.indd 11
This is a device to protect children from being accidentally hurt while playing
with the washer.
• How to start the Child-Lock function:
- Press the "Power" button to go to an initial washing mode.
- By pressing "start/pause" button, you start washing and in case Child Lock
function is needed during the laundry
- Press both the "Rinse" and "Spin" buttons at the same times.(for 3 seconds)
(Note: You cannot perform the function without the "Power" button on.)
• To release the function of Child-Lock: In case the "Child-Lock" is
programmed, press both the "Rinse" and "Spin" buttons at the same time.
Displays the remaining wash time.
Displays the reserved delay start time.
Displays the error state if a problem occurs in the washing machine so that
you can take action.
Press this button to perform a soak wash.
You can set the soak time from between 10 to 60 minutes.
Press this button to finish the wash at a specified time.
Turn off your washing machine to cancel a reserved delay start.
You can set the delay start time from between 3 to 19 hours.
Press this button to load the settings for the last course.
Perform a wash course using the last used settings without having to enter
them manually again.
Your choices are automatically saved when you press the Start/Hold button.
To use a memorized course, press the Last Settings button and then press
the Start/Hold button.
- The memorized functions will be displayed on the panel.
The Delay start and Water level settings are not automatically saved
and will be reset after the wash.
CAUTION
The water level is automatically adjusted. However, you can select the water
level manually by pressing this button.
Each press of the button cycles through the type of water,
Cold  Cold + Hot  Hot  Cold
setting up your washer_11
2012-12-18 7:09:33