HQ Power VDL7510S Manual

HQ Power VDL7510S Manual

'sunstrip' blinder
Table of Contents
  • Algemene Richtlijnen
  • Reiniging en Onderhoud
  • Technische Specificaties
  • Prescriptions de Sécurité
  • Directives Générales
  • Nettoyage et Entretien
  • Spécifications Techniques
  • Introducción & Características
  • Instrucciones de Seguridad
  • Normas Generales
  • Instalación
  • Limpieza y Mantenimiento
  • Especificaciones
  • Einführung & Eigenschaften
  • Allgemeine Richtlinien
  • Reinigung und Wartung
  • Technische Daten

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Quick Links

1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the VDL7510S! Used for stage, exhibition, fashion-shows, etc. Please read the manual thoroughly
before bringing this device into service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is designed for professional use on stage, in discos, theatres, etc. The VDL7510S should only be
used indoors with an alternating current of max. 230VAC / 50Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture. Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
VDL7510S
VDL7510S – 'SUNSTRIP' BLINDER
1
VELLEMAN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VDL7510S and is the answer not in the manual?

Questions and answers

Summary of Contents for HQ Power VDL7510S

  • Page 1 • Keep the device away from children and unauthorised users. 3. General Guidelines • This device is designed for professional use on stage, in discos, theatres, etc. The VDL7510S should only be used indoors with an alternating current of max. 230VAC / 50Hz.
  • Page 2: Installation

    • Overhead mounting requires extensive experience: calculating workload limits, determining the installation material to be used. Have the material and the device itself checked regularly. Do not attempt to install the device yourself if you lack these qualifications as improper installation may result in injuries. VDL7510S VELLEMAN...
  • Page 3: Technical Specifications

    45°C Max. Housing Temperature 130°C The information in this manual is subject to change without prior notice. VDL7510S – ‘SUNSTRIP’ BLINDER 1. Inleiding en kenmerken Aan alle ingezetenen van de Europese Unie Belangrijke milieu-informatie betreffende dit product Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt weggeworpen, dit toestel schade kan toebrengen aan het milieu.
  • Page 4: Algemene Richtlijnen

    Dank u voor uw aankoop! De VDL7510S kan gebruikt worden op podia, beurzen, modeshows, enz. Lees deze handleiding grondig voor u het toestel in gebruik neemt. Werd het toestel beschadigd tijdens het transport, installeer het dan niet en raadpleeg uw dealer.
  • Page 5: Reiniging En Onderhoud

    5. Ontkoppel het toestel van het lichtnet voor u aan onderhoudswerkzaamheden begint. 6. Maak het toestel geregeld schoon met een vochtige, niet pluizende doek. Gebruik geen alcohol of solvent. 7. De gebruiker mag geen onderdelen vervangen, de lamp uitgezonderd. 8. Bestel eventuele reserveonderdelen bij uw dealer. VDL7510S VELLEMAN...
  • Page 6: Technische Specificaties

    45°C Max. temperatuur behuizing 130°C De informatie in deze handleiding kan te allen tijde worden gewijzigd zonder voorafgaande kennisgeving. VDL7510S – ‘SUNSTRIP’ BLINDER 1. Introduction et caractéristiques Aux résidents de l'Union Européenne Des informations environnementales importantes concernant ce produit Ce symbole sur l'appareil ou l'emballage indique que, si l'appareil est jeté après sa vie, il peut nuire à...
  • Page 7: Directives Générales

    • Ne regardez pas directement la source lumineuse comme ceci peut entraîner des crises d'épilepsie chez certains gens. • Les dommages occasionnés par des modifications à l'appareil par le client, ne tombent pas sous la garantie. • Gardez votre VDL7510S hors de la portée de personnes non qualifiées et de jeunes enfants. 3. Directives générales •...
  • Page 8: Nettoyage Et Entretien

    Température max. du boîtier 130°C Toutes les informations présentées dans cette notice peuvent être modifiées sans notification préalable. VDL7510S – ‘SUNSTRIP’ BLINDER 1. Introducción & Características A los ciudadanos de la Unión Europea Importantes informaciones sobre el medio ambiente concerniente este producto Este símbolo en este aparato o el embalaje indica que, si tira las muestras inservibles, podrían dañar el...
  • Page 9: Instrucciones De Seguridad

    • Por razones de seguridad, las modificaciones no autorizadas del aparato están prohibidas. • Utilice sólo el VDL7510S para las aplicaciones descritas en este manual a fin de evitar p.ej. cortocircuitos, quemaduras, descargas eléctricas, etc. Un uso desautorizado puede causar daños y anula la garantía completamente.
  • Page 10: Instalación

    • El soporte donde irá el aparato, debe ser capaz de sostener 10 veces el peso de éste durante una hora, sin que se produzca una deformación de dicho soporte. • Fije el VDL7510S con un cable de seguridad adicional (p.ej. VDLSC7 o VDLSC8). • Evite ponerse debajo del aparato durante el montaje, la limpieza, etc. Un técnico especializado debe revisar el aparato antes de la puesta en marcha.
  • Page 11: Especificaciones

    Respektieren Sie die örtlichen Umweltvorschriften. Falls Zweifel bestehen, wenden Sie sich für Entsorgungsrichtlinien an Ihre örtliche Behörde. Danke für Ihren Ankauf! Der VDL7510S ist zur Anwendung auf Bühnen, Messen, Modenschauen, usw. konzipiert worden. Lesen Sie diese Bedienungsanleitung sorgfältig durch. Überprüfen Sie, ob Transportschäden vorliegen.
  • Page 12: Allgemeine Richtlinien

    1. Drehen Sie die Schraube des Lüftungsdeckels los und entfernen Sie vorsichtig den Deckel. 2. Ersetzen Sie die alte durch eine neue Lampe. 3. Bringen Sie den Deckel wieder an und drehen Sie die Schraube fest. Bemerkung: Schalten Sie das Gerät niemals ein, ohne vorher den Deckel geschlossen zu haben. VDL7510S VELLEMAN...
  • Page 13: Reinigung Und Wartung

    8. Technische Daten Stromversorgung max. 230VAC / 50Hz Abmessungen 1250 x 75 x 75mm Gewicht 7.5kg Lampe 10 x ELC MR16 – 24V / 70W (Artikelnummer: LAMP75/24S) Farbtemperatur 3200K Max. Umgebungstemperatur 45°C Max. Gehäusetemperatur 130°C Alle Änderungen vorbehalten. VDL7510S VELLEMAN...

Table of Contents