1. Manuals
  2. Brands
  3. Phason Manuals
  4. Monitor
  5. AutoFlex Connect II
  6. Manual

Phason Autoflex Connect II Manual

Hide thumbs Also See for Autoflex Connect II:
1
2
3
4

Advertisement

Table of Contents

AutoFlex Connect II display kit
This procedure explains how to install AutoFlex Connect II
display kit (model
KAFXC2-DISPLAY)
they are listed.

Create a new database backup

A.
Shut down AutoFlex Connect
B.
C.
D.
E.
F.
A. Create a new database backup
If your AutoFlex Connect II is not functioning, skip to section B.
Create the backup on the
Your control might look different than the pictures in the examples but the
procedure is the same.
1. At the control, press the main menu and then
.
Administration
2. On the Admin Panel, press
3. Press
and then press
Eject USB
the instructions on the screen. If a message
displays that it is safe to remove the USB
drive,
DO NOT press Okay
4. Loosen the three screws that secure the cover
and then open the cover.
5. Remove the USB drive that
6. On the new display, remove the USB drive that
7. Plug the new USB drive into the port where you removed the old USB drive from in step 4.
8. Press
.
Okay
9. Swipe to the right or left until you see the Backup Database icon.
10. Press
Backup Database
11. Press
and then wait for the backup to complete.
Yes
12. Eject the USB drive as you did in step 3.
13. Remove the USB drive.
14. Plug the old USB drive into the port and then press
Phason
. Follow the steps in the order
USB drive that
new
.
Diagnostics
. Follow
Yes
.
have the WARNING label.
DOES NOT
.
have the WARNING label.
DOES NOT
have the WARNING label.
DOES NOT
.
Okay
REMOVE
DO NOT
REMOVE
34440600

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Autoflex Connect II and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Phason Autoflex Connect II

Summary of Contents for Phason Autoflex Connect II

  • Page 1 Remove the old display Install the new display Power on and test the system A. Create a new database backup If your AutoFlex Connect II is not functioning, skip to section B.  Create the backup on the USB drive that have the WARNING label.
  • Page 2 B. Shut down AutoFlex Connect II If you can access the menus at the control or from a web browser, start at step 1. If you cannot access the menus, start at step 3. 1. On the Diagnostics screen, swipe right or left until you see the Shut Down Display icon.
  • Page 3 Start at the top hinge and then work downward. 4. Connect the ribbon cable from the module mounting board to the Communication Controller. 5. Verify all wires, cables and USB drives are properly connected. Phason 34440600...
  • Page 4 2. Wait for L6 to go OFF. 3. Reinsert the tab between the battery and contact. L1 and L2 will be OFF when the tab is correctly inserted. Phason 2 Terracon Place Phone: 204-233-1400 Winnipeg, Manitoba, Canada E-mail: support@phason.ca R2J 4G7 Web: www.phason.ca...

This manual is also suitable for:

Kafxc2-display

Table of Contents