Phason AutoSort CONNECT KASC-DISPLAY Installation Manual

AutoSort Connect display kit installation guide
This procedure explains how to install AutoSort Connect display kit model
the steps in the order they are listed.
A. Create a new database backup
B. Shut down AutoSort Connect
C. Verify the database backup
D. Remove the old display
A. Create a new database backup
If your AutoSort Connect is not functioning, skip to

You must create the backup on the

WARNING label.
Your control might look different than the pictures in the examples but the

procedure is the same.
1. At the control, press the main menu and then
2. On the Admin Panel, press
3. Press , and then press
Eject USB
displays that it is safe to remove the USB drive,
4. Remove the four screws fastening the cover in place and then open the cover.
5. Remove the USB drive that
6. On the new display, remove the USB drive that
7. Plug the new USB drive into the port where you removed the old USB drive from in step 4.
8. On the Diagnostics screen, press
9. Swipe to the right or left until you see the Backup Database icon.
10. Press
Backup Database
11. Press and then wait for the backup to complete.
Yes
35040600
Administration
.
Diagnostics
. Carefully follow the instructions on the screen. If a message
Yes
have the WARNING label.
DOES NOT
.
Okay
.
KASC-DISPLAY
E. Install the new display
F. Start AutoSort and restore from the
backup
G. Update AutoSort
C. Verify the database backup
USB drive that
new DOES NOT
.
.
DO NOT press Okay
have the WARNING label.
DOES NOT
. Follow
.
have the
1 of 4