Cisco 3660 Installation Manual page 5

Chapter 4 Installation on Cisco 3660 Routers
Before performing any of the following procedures, ensure that power is removed from the DC
Warning
circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services
the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the
circuit breaker in the OFF position. To see translations of the warnings that appear in this
publication, refer to the Regulatory Compliance and Safety Information document that
accompanied this device.
Strip one end of the 6-AWG wire to expose approximately 0.75 in. (20 mm).
Step 2
Crimp the ground lug around the wire. (See
Step 3
Figure 4-7
Use the number 2 Phillips screwdriver to fasten the ground lug to the Cisco 3660 router chassis. (See
Step 4
Figure
78-5450-06 B0
Crimping the Lug Around the Wire
4-8.)
NEBS Level 3 and ETSI Compliance Kit Installation Guide for Cisco 3620, Cisco 3640, and Cisco 3660 Routers
Figure 4-7.)
Installing the Ground Lug
4-5