Scanner - CipherLab RK25 Reference Manual

RK25 Mobile Computer

SCANNER

Scan a 1D barcode

1) Open
ReaderConfig
2) Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3) Press any of the two side triggers. The scanning light beams to read the printed
barcodes. The buzzer beeps after scanning. The scanning light goes off once the data is
decoded, or when the decode timeout period has passed.
Scan a 2D barcode

1) Open
ReaderConfig
2) Aim the scanning window at the barcode to read. Move the device, having the barcode
located in the center of the scanning area.
3) Press any of the two side triggers. The scanning light beams to read the printed
barcodes. The buzzer beeps after scanning. The scanning light goes off once the data is
decoded, or when the decode timeout period has passed.
CONNECTION
Via Bluetooth or WLAN
Connection may fail when the mobile computer is around other wireless machines or

power cables as the radio frequencies of those may cause interferences.
If communication fails, move the devices much closer to each other, and try to

communicate again
After turning on, Bluetooth power is sustained even when the mobile computer is

suspended. However, if the power mode is switched to Airplane Mode, Bluetooth power
will be turned off regardless of the settings.
To a Charging & Communication Cradle
Do not insert the mobile computer to a Charging & Communication Cradle if water or

drippings are staying on the device.
 The LED indicator on a Charging & Communication Cradle shows the status of battery
charging only; the status of terminal charging is shown on the device itself.
Not Charging could be the result of battery damage, battery's failure to touch the

connector or AC plug coming off.
Charging error could be due to high battery temperature.

and tap on the menu bar.
Scan Test
and tap on the menu bar.
Scan Test
- 8 -