Table of Contents
Advertisement
IMPORTANT: The appliance is exposed to
extreme changes in temperature and may,
as a result, make noises when in operation.
These noises are a natural result of
expansion/contraction of the parts which
make up the appliance. Do not be alarmed
by noises of this kind.
In order to obtain maximum output,
open all the air intakes to the firebox and
in order to obtain minimum output, tend
towards closing them.
For normal use, we recommend you the
air Intake 50 % open.
(a)
High burn rate: The appliance shall
be operated with combustion rate controls
fully open.
(b)
Low burn rate: The appliance shall
be operated with all combustion rate
controls adjusted to the minimum setting.
(c)
Medium burn rate: The appliance
shall be operated with the register in the
middle of its position.
Lacunza recommends doing medium burn
cycles.
3.6. Removing ash
Following
sustained
appliance, it is necessary to remove the ash
from the firebox. Remove the ashpit box
when cold or using something to prevent
yourself from getting burned (glove).
Never throw hot embers into the
rubbish.
Access the ashpit by opening the door
on the appliance.
INSTRUCTIONS OF USE
use
of
the
3.7. Deflectors.
The
appliance
deflector
and
reinforcement.
Removing the Nickel deflector
Follow the next steps:
First, remove the 2 separators.
Figure No.14 - Removing the two
separators.
Figure No.15 - Removing the cast iron
grilles
16
3.
has
1
vermiculite
2
stainless-steel
Advertisement
Table of Contents
