PRESENTATION OF THE APPLIANCE Lacunza congratulates you on your choice. Certified under ISO 9001, Lacunza guarantees the quality of its appliances and undertakes to meet the needs of its customers. Confident of the know-how afforded by more than 50 years’ experience, Lacunza uses advanced technologies in the design and manufacture of its entire range of appliances.
Page 3
PRESENTATION OF THE APPLIANCE 4.1.5. Firebox glass .................................. 18 4.1.6. Air intake registers ................................ 18 4.2. Maintenance of the chimney flue ........................19 4.3. Important advice .............................. 19 TROUBLESHOOTING .......................... 20 BASIC BREAKDOWNS ........................21 CERTIFICATE OF COMPLIANCE ......................22...
PRESENTATION OF THE APPLIANCE PRESENTATION OF THE APPLIANCE For optimum operation of the appliance, we advise you to read this manual carefully before switching on the appliance for the first time. In case of problems or concerns, we urge you to contact your dealer, who will cooperate with you.
Page 5
Instruction Book. Failure to respect these conditions may lead to problems with the appliance (deterioration, shorter useful life, etc.) which are not covered by the Lacunza warranty.
Page 6
PRESENTATION OF THE APPLIANCE Figure No.2 - Dimensions of the Verona 1001 appliance in mm...
Page 7
PRESENTATION OF THE APPLIANCE Figure No.3 - Dimensions of the Verona 1003 appliance in mm...
P ≤ 10kW fixtures, etc.). 10 < P ≤ 15 Lacunza’s liability is limited to the 15 < P ≤ 20 supply of the material and does not include 20 < P ≤ 25 installation of the appliance.
INSTRUCTIONS FOR THE INSTALLER closable outside-air inlet with a section of should be used in front of each of the at least 90 cm². appliance doors and be placed centrally in the 1320mm width. The Thermal resistivity 2.2.2. Location of the appliance in the of the 50mm skamol board floor protector room is 0.74m².K/W.
INSTRUCTIONS FOR THE INSTALLER • Make sure that the airtight joints the total length (12 meters) 1 meter for each accessory used. on the flue circuit are in perfect condition. This is the best option because it means • Make sure that the doors close that draughts are not created in and properly.
INSTRUCTIONS FOR THE INSTALLER Figure No.7 - Piping air to the firebox in If the chimney is constructed, then it is Verona 1001 necessary to pipe and insulate it to ensure correct updraught. The diameter of the pipe must be the same as the diameter of the flue socket on the appliance over its entire length in order to ensure correct operation.
INSTRUCTIONS FOR THE INSTALLER combustible material in order to prevent breakage, deformation, etc., as a result of overheating if the material is not designed to withstand high temperatures. It must be possible to clean the entire flue, no sections being left inaccessible for cleaning purposes.
Page 13
INSTRUCTIONS FOR THE INSTALLER Figure No.11 - Distances between the chimney crown and objects within a radius of between 10 and 20m...
INSTRUCTIONS OF USE Non-permitted fuels: INSTRUCTIONS OF USE • All types of coal and liquid fuel. The manufacturer accepts no liability • “Green wood”. Green or damp whatsoever for damage caused to parts as wood reduces the performance of the a result of the improper use of non- appliance and leads to soot and tar recommended fuels, modifications made...
INSTRUCTIONS OF USE 3.2. Description of the parts of the appliance 3.2.1. Operating components Figure No.13 - Operating components on the appliance • A: Firebox door handle • B: Air intake B1 closed (left) B2 open (right)
INSTRUCTIONS OF USE 3.4. Loading fuel 3.3. Lighting In order to load firewood, open the Use of the appliance in warm weather firebox door gently, preventing the sudden (warm days, early hours of the afternoon entry of air to the firebox so that smoke on sunny days) may lead to lighting and does not enter the room that the appliance updraught problems.
Figure No.14 - Removing the two Medium burn rate: The appliance separators. shall be operated with the register in the middle of its position. Lacunza recommends doing medium burn cycles. 3.6. Removing ash Following sustained appliance, it is necessary to remove the ash from the firebox.
Page 18
INSTRUCTIONS OF USE Figure No.16 - Remove the refractory from the right side Figure No.19 - Remove de deflector. Figure No.17 - Turn the right-side refractory as in the picture so that the deflector can fall Figure No.18 - Drop the refractory holding...
MAINTENANCE AND IMPORTANT ADVICE specific degreasing products MAINTENANCE AND cleaning products for this task. IMPORTANT ADVICE The cleaning should be carried out with the glass cold and taking care not to apply 4.1. Maintenance of the appliance the glass cleaner directly on the glass as, if it comes into contact with the door's The appliance, the flue connector piping closing cord, it may deteriorate.
VERY IMPORTANT: In order to avoid used. incidents (chimney fires, etc.), it is necessary to perform maintenance and Lacunza accepts no liability for any cleaning operations on a regular basis; if modification to the product which it has the appliance is used often, then the not authorised.
TROUBLESHOOTING TROUBLESHOOTING This symbol means that a qualified professional should be called to perform the operation. Problem Probable causes Solution Use hard woods, cut at least 2 years ago and stored in a Green or damp wood sheltered, ventilated place Use crumpled paper or firelighters and dry wood chips to light The logs are too large the fire.