Linear Logic ScangaugeD Quick Start Manual page 6

3) Fuel Level and Cost Adjustments
The FILLUP function allows you adjust and
enter the fuel level and cost values to help
ScanGauge maintain accurate TO EMPTY
and FUEL COST computations.
Initial Setup
To set the tank level initially, access the
FILLUP screen and use the upper left and
right function buttons to adjust the "TANK="
value to what you estimate is in the tank.
Using the FILLUP Screen
Use the FILLUP screen each time you put
fuel in the tank. Adjust the number shown
in the top line using the upper left and right
function buttons until the number matches
the amount of fuel you put in the tank.
You can increase the number in 10 gallon/
liter steps and decrease in 1 gallon/liter
steps.
If you're tank is full, press the function
button next to "+10" until the "TANK=" value
is the same as the tank capacity.
Helpful Hints
•
If you fill up your fuel tank with your ve-
hicle on an incline, it can have an effect
on the amount of fuel the pump can dis-
pense into your tank.
•
When filling your tank, let the pump shut
off automatically. Do not top off.
<SCAN
<TRIP
<DISPLAY
<SETUP
FILLUP Screen
<-1
Tank=
Fuel Cost Screen
< $4.10
Fuel Cost
Push the SAVE button to complete the FILLUP process
and reset the TRIP parameters related to fuel.
Fuel Cost Screen
When you're done adjusting the fuel,
press the NEXT button to access the Fuel
Cost Screen. Use the upper left and right
function buttons to adjust the fuel cost, then
press SAVE.
•
To maintain the most accurate "TO EMP-
TY" information, it is best to fill the tank
to its capacity
GAUGE>
MORE>
FILLUP>
MORE>
0 +10>
85 NEXT>
>
SAVE>