Table of Contents
Advertisement
Quick Links
Model Information
Index
Front Panel
Rear Panel
Remote Control
Warranty
Reset Procedure
Accessories
Protection History
Display Mode
Upgrades/Updates
Product Specifications
I/R Codes
NOTE:
This edition is missing the FAQ's content (pages 13 and 14) .................................................................7/29/2015
This edition is missing the link to the IR Codes.....................................................................................7/29/2015
MODEL:
Model Information
INTEGRATED NETWORK AV RECEIVER
AVR-X2000W
1
MI072915E3-1
Advertisement
Table of Contents
Related Manuals for D+M Group AVR-X2000W
Summary of Contents for D+M Group AVR-X2000W
- Page 1 MODEL: AVR-X2000W Model Information Index Model Information Front Panel INTEGRATED NETWORK AV RECEIVER Rear Panel Remote Control Warranty Reset Procedure Accessories Protection History Display Mode Upgrades/Updates Product Specifications I/R Codes NOTE: This edition is missing the FAQ’s content (pages 13 and 14) ………………………………………………………..7/29/2015 This edition is missing the link to the IR Codes………………………………………………………………………..7/29/2015...
- Page 2 Front Panel (1 of 2) Power operation button (O) USB port This turns the power of MAIN ZONE on/off (standby). Used to connect USB storages (such as USB memory devices) and the Power indicator USB cable supplied with iPod. This is lit as follows according to the power status: ...
- Page 3 Front Panel (2 of 2) ZONE2 ON/OFF button This turns the power of ZONE2 on/off. ZONE2 SOURCE button This selects the input source for ZONE2. DIMMER button Each press of this switches the brightness of the display. ...
- Page 4 Display (1 of 2) Sleep timer indicator Information display The input source name, sound mode, setting values and other This lights when the sleep mode is selected. information are displayed here. Tuner reception mode indicators These light according to the reception conditions when the input Input signal indicators source is set to “TUNER”.
- Page 5 Display (2 of 2) Decoder indicator These light when Dolby or DTS signals are input or when the Dolby or DTS decoder is running. Surround back indicator This lights when audio signals are being output from the surround back speakers .
- Page 6 Rear Panel FM/AM antenna terminals (ANTENNA) Network connector (NETWORK) Used to connect FM and AM antennas. Used to connect this unit to the network. Speaker terminals (SPEAKERS) PRE OUT connectors Used to connect speakers. Used to connect a subwoofer with a built-in amplifier or an external power amplifier. ...
-
Page 7: Remote Control (1 Of 2)
Remote Control (1 of 2) ZONE SELECT buttons (MAIN, ZONE2) These switch the zone (MAIN ZONE, ZONE2) that is operated through the remote control unit. Input source select buttons These select the input source. FAVORITE STATION buttons (1 – 3) With a single press of these, you can call up registered radio stations and contents. -
Page 8: Remote Control (2 Of 2)
Remote Control (2 of 2) SOUND MODE buttons These select the sound mode. • MOVIE button • MUSIC button • GAME button • PURE button Remote control signal transmitter This transmits signals from the remote control unit. SLEEP button This sets the sleep timer. -
Page 9: Denon Limited Warranty (1 Of 2)
DENON LIMITED WARRANTY (1 of 2) This warranty will be honored only in the U.S.A. Length of Non-Transferable Warranty This warranty on your DENON product which is distributed and warranted by DENON ELECTRONICS (USA), LLC remains in effect for the following periods from the date of the original consumer purchase from an AUTHORIZED DENON ELECTRONICS (USA), LLC DEALER. - Page 10 Warranty (2 of 2) What is Covered Except as specified below, this Warranty covers all defects in material and workmanship in this product occurring during the above warranty periods. The following are not covered by the Warranty: (1) Any product which is not distributed in the U.S.A. by DENON ELECTRONICS (USA), LLC. (2) Any product which is not purchased in the U.S.A.
- Page 11 Reset Important: Back up the settings before resetting the microprocessor. Most settings are reset to the factory default values after performing this procedure. This means that all the settings data will be completely lost if it’s not previously saved. Power/Standby button Reset procedure: With the power off, press and hold the “TUNER...
- Page 12 Accessories Sound Remote Control Sound Calibration (RC1183) Calibration Microphone Microphone Stand (ACM1HB) 30701013800AD $48.99 32401000800AD $31.99 963549101000D $16.82 AM Loop FM Indoor Antenna Antenna 963116100070S $8.99 963116100080S $3.27 90M-ZC000470R $30.64 Safety CD ROM Instructions Owner’s Manual Warranty Notes on Radio Quick Start (For North Guide...
- Page 13 FAQ’s ( 1 of ?) HOME ACCESSORIES FAQ’s 2...
- Page 14 FAQ’s (2 of ?) HOME FAQ’s 1 UPGRADE...
- Page 15 Press “SETUP” and select “GENERAL” and then select “FIRMWARE” followed by “UPDATE” and finally, select “CHECK FOR UPDATE”. Note: This will also check the time it will approximately take to complete the update. To download the latest version of firmware for AVR-X2000W, click on the following Upgrade page: www.usa.denon.com/US/Downloads/Pages/Product-Updates.aspx To display the AVR’s current firmware version on the TV screen:...
-
Page 16: Specifications - Audio Section
Specifications – Audio Section Audio section 95 W + 95 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.) Front 125 W + 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) 95 W (8 Ω/ohms, 20 Hz – 20 kHz with 0.08 % T.H.D.) Center 125 W (6 Ω/ohms, 1 kHz with 0.7 % T.H.D.) Rated output... -
Page 17: Specifications - Tuner Section, General Section
Specifications - Tuner Section, General Section Tuner section Note: µV at 75 Ω/ohms, 0 dBf = 1x10 Reception frequency range 87.5 MHz - 107.9 MHz 520 KHz -1710 KHz Effective sensitivity 1.2 µV (12.8 dBf) 18µV 50 dB sensitivity MONO ― 2.8 μV (20.2 dBf) MONO 70 dB (IHF–A weighted, Direct mode) S/N ratio... -
Page 18: Specifications - Dimensions, Weight
Specifications – Dimensions, Weight Dimensions section (Unit : inch/mm) Weight: 20 lbs 15 oz (9.5 kg) HOME SPECIFICATIONS - SPECIFICATIONS - TUNER – AUDIO GENERAL... - Page 19 The End NOTE: This edition is missing the FAQ’s content (pages 13 and 14) ………………………………………………………..7/29/2015 This edition is missing the link to the IR Codes………………………………………………………………………..7/29/2015 HOME...