Other External Component Operations - JVC KD-G747 Instructions Manual

Indications Item
(
L/O MODE • REAR
Line output mode
• SUB.W
SUB.W FREQ *
5 • LOW
Subwoofer cutoff • MID
frequency • HIGH
TAG DISPLAY • TAG ON
Tag display • TAG OFF
AMP GAIN • LOW POWER
Amplifier gain control
• HIGH POWER
IF BAND • AUTO
Intermediate
frequency band • WIDE
* 5 Displayed only when "L/O MODE" is set to "SUB.W."

Other external component operations

You can connect an external component to the
AUX (auxiliary) input jack on the control panel.
Portable audio player, etc
~
Selectable settings, [reference page]
: Initial)
: Select if the REAR LINE OUT terminals are used for connecting the
speakers (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a
subwoofer (through an external amplifier).
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
: Shows the Tag information while playing MP3/WMA tracks, [13].
: Cancels.
: VOLUME 00 – VOLUME 30 (Select this if the maximum power of the
speaker is less than 50 W to avoid them from damaging the speaker.)
: VOLUME 00 – VOLUME 50
: Increases the tuner selectivity to reduce interference noise between
close stations. (The stereo effect may be lost.)
: Subject to the interference noise from adjacent stations, but the
sound quality will not be degraded and the stereo effect will remain.
3.5 mm stereo mini
plug (not supplied)
Ÿ
Turn on the connected component and
start playing the source.
!
Adjust the volume.
⁄
Adjust the sound as you want. (See
page 14.)
To check the other information while
listening to an external component
AUX IN Ô Clock
17