Table of Contents
Advertisement
VIDEO RECORDING
22
EN
2) Point the lens toward the subject (yourself
when self-recording) and start recording.
● During Interface Shooting, the monitor image
appears inverted as it would when viewing a
mirror. However, the actual recorded image does
not appear inverted.
● If the Quick Review
the interface- shooting, the LCD monitor will be
turned off.
● In such a case, check the playback picture in the
viewfinder. To check the playback picture in the
LCD monitor, close the viewfinder.
Time Code
During recording, a time code is recorded on the
tape. This code is to confirm the location of the
recorded scene on the tape during playback.
Display
12 : 34 : 24
* Frames are not displayed during recording.
If recording starts from a blank portion, the time
code begins counting from "00:00:00"
(minute:second:frame). If recording starts from
the end of a previously recorded scene,
the time code continues from the last time code
number. If during recording a blank portion is left
partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
"00:00:00". This means the camcorder may
record the same time codes as those existing in
a previously recorded scene. To prevent this,
perform "Recording From The Middle Of A Tape"
pg. 22) in the following cases;
(
● When shooting again after playing back a
recorded tape.
● When power shuts off during shooting.
● When a tape is removed and re-inserted during
shooting.
● When shooting using a partially recorded tape.
● When shooting on a blank portion located partway
through the tape.
● When shooting again after shooting a scene then
opening/closing the cassette holder cover.
NOTES:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time
code indication does not move smoothly.
● The time code is displayed only when "TIME
CODE" is set to "ON". (
(
pg. 22) is executed during
Minutes
Seconds
Frames*
(25 frames = 1 second)
pg. 34)
Quick Review
Enables to check the end of the last recording.
1) Press QUICK REVIEW during the Recording-
Standby mode.
2) Tape is rewound for about several seconds
and played back automatically, then pauses in
the Recording-Standby mode for the next shot.
● Distortion may occur at start of playback. This is
normal.
Recording From The Middle Of A Tape
1) Play back a tape or use Blank Search
(
pg. 23) to find the spot at which you want to
start recording, then engage the Still Playback
mode. (
pg. 23)
2) Set the Power Switch to "REC" while pressing
down the Lock Button located on the switch,
then start recording.
Advertisement
Table of Contents
