Advertisement
W
iring diagram
[1] Wiring of LED Lead Wire on Blade Case
Route as illustrated in Figs. D-2, D-3.
Fig. D-2
Fix Protective tube that covers LED lead wires
with Lead wire holder on Blade case.
LED circuit
Lead wire holder
[Blade case viewed from Handle R side]
[2] Wiring Lead Wires of Endbell Complete in/on Motor Section
1) Route on the inside of Housing L as illustrated in Fig. D-4.
Note: Assemble Housing R to Housing L after completion of wiring on the inside of Housing L.
2) Route on the front of Housing R as illustrated in Fig. D-5.
Note: Assemble Gear housing to Motor section after completion of wiring on the front of Housing R.
Fig. D-4
Endbell complete
Fix Lead wires with
these Lead wire holders.
Protective tube
Connector
Housing L
Lead wire holder
through hole
Pull out from this through hole.
Fig. D-3
Pull out LED lead wires from the hole in Blade case
as illustrated below.
Handle R
Connector
Fig. D-5
[Motor section viewed from front]
Housing R
groove
Route through this groove.
P 12/13
opening
Blade case
Housing L
through hole
Lead wire holder
Fix with Lead wire holder.
Advertisement
