Table of Contents
Advertisement
VT-16P250WS / VT-24P370WS: 16 / 24 Port L2 Web Smart Ethernet PoE Switch
5.1 Management Options
The Switch can be managed through any port on the device by using the Web-based Management
Each switch must be assigned its own IP Address, which is used for communication with Web-Based Management.
The PC's IP address should be in the same range as the switch. Each switch can allow only one user to access the
Web-Based Management at a time.
Please refer to the following installation instructions for the Web-based Management.
5.2 Using Web-based Management
After a successful physical installation, you can configure the switch, monitor the network status, and display
statistics using a web browser.
Connecting to the Switch
You will need the following equipment to begin the web configuration of your device:
A PC with a RJ-45 Ethernet connection
n
A standard Ethernet cable
n
Connect the Ethernet cable to any of the ports on the front panel of the switch and to the Ethernet port on the PC.
Login Web-based Management
In order to login and configure the switch via an Ethernet connection, the PC must have an IP address in the same
subnet as the switch. For example, if the switch has an IP address of 192.168.2.1, the PC should have an IP address
of 192.168.2.x (where x is a number between 2 ~ 254), and a subnet mask of 255.255.255.0. Open the web browser
and enter 192.168.2.1 (the factory-default IP address) in the address bar. Then press <Enter>.
When the following logon dialog box appears, enter the username and password then click OK. The default
username is admin and password is system.
6
Configuration
The features and functions of the switch can be configured for optimum use through the Web-based Management.
6.1 Welcome
After a successful login you will see the screen bellows:
8
Advertisement
Table of Contents
