Table of Contents
Advertisement
Steering Wheel Interface(SWI) Operation
SETTING
In the event of the interface, you can set the function value of the button, touch the
N/A area will pop-up the value, touch the button up or down to search the function
value. When the selected value to touch it determine the value by the button; You can
set the unit's system a total of six buttons, there are ten optional functions: VOL-/VOL
(volume adjustment), CH-/CH(TV channel scan), SEEK-/SEEK(manual fine-tuning(short
press)/scan channels(long press), MUTE, MODE, POWER, Talk; Will be set after the
button above. Pressing [return] icon after setting. As shown below:
RESET
From the point we can see, setting up five buttons, set the VOL+,VOL-,CH+,CH-, MODE
five functions according to individual needs, set the button's function corresponding value.
When the need to re-set button on the steering wheel controller efunction value, touch
[RESET] button to life the value of the button's function, then repeat the above steps,
re-set the desired fuction value.
SWI Wiring Diagram
Single-wire analog steering wheel controller
R1
R2
S1
S2
Double-wire analog steering wheel controller
R2
S2
S5
R5
R4
R3
R4
R5
R6
S3
S4
S5
S6
SWC1
R1
R6
S1
S5
S4
S3
R3
SWC2
J1
1
Steering wheel controller' s SWC1
2
3
4
Steering wheel controller' s SWC-GND
Steering wheel controller' s SWC1
Steering wheel controller' s SWC-GND
Steering wheel controller' s SWC2
Advertisement
Table of Contents
