Care And Cleaning - AEG LAVATHERM 7070TWF User Manual

38 www.aeg.com
3. Push the Start Pause button again
and again until you set necessary
level.
4. To memorise the setting push at the
same time the Dry Plus (Trocken +)
and the Anticrease (Knitterschutz)
buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.

9. CARE AND CLEANING

9.1 Cleaning the primary filter
At the end of each cycle the applicable
indicator (clean the primary filter) is on to
tell you that the primary filter must be
cleaned.
To clean the primary filter:
To activate or deactivate the indication:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Dry Plus
(Trocken +) and Buzzer (Signal) but-
tons and hold down until you see
the correct setting:
– the LED is off and the symbol
goes into the view - The
LED is permanently off
– the LED is on and the symbol
goes into the view - The
LED is activated
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
1. Open the door.
2. Pull the filter.
3. Open the filter.