Table of Contents
Advertisement
Q
Appliance settings
You can change the following appliance
A p p l i a n c e s e t t i n g s
settings:
Settings that can be selected:
End signal
■
off – quiet – medium – loud – very
loud
Adjust the volume of the end signal.
Button signal
■
off – quiet – medium – loud – very
loud
Adjust the volume of the button
signals.
Auto power-off of the appliance
■
in 15 – 30 – 60 min – never
The appliance automatically
switches off after ... minutes (=
0 kWh energy consumption); to
switch on, press the # main switch
button.
Language
■
German
English
...
Change the displayed language.
Info: Drum cleaning
■
on – off
This instruction reminds you to carry
out a drum cleaning programme.
Dispenser content:
■
i-Dos iIô content
Fabric softener - detergent
Select/change the dispenser
content.
Basic dosage:
■
i-Dos iIô basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent/fabric softener
manufacturer.
Basic dosage:
■
i-Dos ô basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent manufacturer.
Appliance settings
To change the settings, press and hold
both basic settings 3 sec. buttons for
approx. 3 seconds. ~ Page 13
Notes
The settings are retained after the
■
appliance is switched off.
If you press and hold the buttons,
■
the settings run through
automatically.
H
Sensors
A utomatic load sensing
S e n s o r s
Depending on the type of fabric and
load, the automatic load sensing
function optimally adjusts the water
consumption and programme duration
in each programme.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum.
~ Page 27, ~ Page 42
AquaSensor
depending on the model
During the rinse cycle, the AquaSensor
checks the degree of turbidity (turbidity
is caused by dirt and detergent residue)
of the rinsing water. The duration and
the number of rinse cycles depend on
the turbidity of the water.
en
35
Advertisement
Table of Contents
