DeWalt DCS335 Instruction Manual page 11

a. For 0° and 45° bevel angles, slide the shoe back and
lock the shoe by moving the shoe bevel lever back
under the body of the jig saw.
b. For all angles between 0° and 45°, lock with bevel
lever only.
Fig. E
Cutting Action—Orbital or Straight (Fig. F)
This jig saw is equipped with four cutting actions, three
orbital and one straight. Orbital action has a more
aggressive blade motion and is designed for cutting in soft
materials like wood or plastic. Orbital action provides a faster
cut, but with a less smooth cut across the material. In orbital
action, the blade moves forward during the cutting stroke in
addition to the up and down motion.
nOTE: Metal or hardwoods should never be cut in
orbital action.
To adjust the cutting action, move the orbital action
lever 6 between the four cutting positions: 0, 1, 2, and 3.
Position 0 is straight cutting. Positions 1, 2, and 3 are orbital
cutting. The aggressiveness of the cut increases as the lever
is adjusted from one to three, with three being the most
aggressive cut.
Fig. F
Dust Blower (Fig. G)
The dust blower helps clear the cutting area of debris
18
created from the blade.
8
7
Dust Extraction (Fig. A, H)
Optional Accessory
nOTE: Recommended accessories for use with your tool
are available at extra cost from an authorized D
service center.
The dust extraction chute in combination with the
dust extraction shroud helps extract dust from the
workpiece surface, when connected to a suitable dust
extraction system.
nOTE: The tool will not bevel if the dust extraction
accessories are attached to the tool.
1. Place the dust extraction shroud
2. Slide the dust chute
3. To connect a vacuum to the dust chute
6
Removeable No-Mar Shoe Cover (Fig. I)
The no-mar shoe cover
surfaces that scratch easily, such as laminate, veneer
or paint.
To attach no-mar shoe cover, place the front of the shoe
into the front of the no-mar shoe cover
jig saw. The no-mar shoe will click securely onto the rear of
the shoe.
Fig. G
guard 5 (Fig. A) until it clicks into place.
15 from the back of the tool until
it snaps into the dust shroud. Be sure the adapter end
is facing up.
D WALT quick connector (DWV9000), found on all full
e
size D WALT vacuum hoses, over the dust collection
e
port, and twist the collar to lock it into place.
Fig. H
14
16 should be used when cutting
English
18
WALT
e
14 onto the finger
15 , place a
15
7
16 and lower the
9