Drainage Hose On The Siphon Blocked - Bosch WVG30441SN Instruction Manual And Installation Instructions

Open and remove the service flap.
3.
Take the drain hose out of the
4.
retainer.
Remove the sealing cap and pour
the water out into a suitable
container.
Replace the sealing cap and place
the drain hose back in the retainer.
Carefully unscrew the pump cover;
5.
residual water may leak out.
Clean the interior, pump-cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
Cleaning and maintenance
To prevent unused detergent
Note:
from flowing into the outlet during the
next wash: Pour 1 litre of water into
dispenser II and start the Spin/Drain 0/
[ programme: (if only a drained cycle
is required: set 0 (rpm) (spin speed) to
0 ).
Drainage hose on the siphon
blocked
Turn the programme selector to Off.
1.
Pull out the mains plug.
Loosen hose clip, carefully remove
2.
drainage hose. Residual water may
run out.
Clean drainage hose and siphon
3.
spigot.
Re-attach the drainage hose and
4.
secure the connection point with the
hose clip.
en
29