Table of Contents
Advertisement
20. Wrap the Long Cable (80) under a 90mm Pulley
(28) as shown. Attach the Pulley and a Pulley
Guard (29) to the Upright (3) with a 3/8" x 4 1/2"
Button Head Bolt (40) and a 3/8" Nylon Locknut
(76). Be sure the flat edge of the Pulley Guard
is on the bottom.
21. Attach a Pulley Housing (94) to the indicated "U"-
channel on the 10-Pound Center Crossbow (44)
with a 3/8" x 4" Bolt (66) and a 3/8" Nylon
Locknut (76).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Pulley
Housing (94) with a 3/8" x 1 1/2" Button Head
Bolt (71) and a 3/8" Nylon Jamnut (103).
22. Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley and a Pulley Guard (29) to
the indicated 3/8" x 5 1/2" Carriage Bolt (73) with
a 3/8" Nylon Locknut (76). Be sure the flat edge
of the Pulley Guard is on the side shown.
23. Make sure there are no Crossbows (not shown)
under the "U"-channels on the 10-Pound Center
Crossbow (not shown). Have a second person
pull on the Long Cable (80) to create slack in the
Cable.
Insert the end of the Long Cable (80) through the
welded tube on the indicated end of the Cross
Tube (11) and then through the remaining Swivel
Arm (22). Be sure the Cable is on the indicated
side of the welded rod in the Swivel Arm.
Insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with a #8 x 3/8" Screw (24).
Wrap the Long Cable (80) around a 90mm Pulley
(28). Attach the Pulley inside of the Swivel Arm
(22) with a 3/8" x 1 1/2" Button Head Bolt (71)
and a 3/8" Nylon Jamnut (103).
20
3
40
21
44
94
66
71
22
28
80
Flat
Edge
23
71
Rod
80
28
103
11
28
76
29
80
Flat
Edge
76
103
28
80
29
76
73
22 24
11
Advertisement
Table of Contents
