Table of Contents
Advertisement
HCD-DP1000D
4. SACD
[4]
Select
, insert SACD disc, and press
adjustment will be made through the following steps, then adjusted
values will be written to the EEPROM. However, if SACD disc is
not available, use the player with initial data, skipping the SACD
adjustment. In this case, you can finish the adjustment if pressing
the x button.
SACD Adjustment Steps
1. Sled Tilt Reset
2. Set Disc Type CD
3. LD ON
4. Spdl Start
5. Wait 500 msec
6. Focus Servo ON 0
7. Auto track Offset Adjust
8. CLVA ON
9. Wait 500 msec
10. Tracking ON
11. Wait 1 sec
12. Sled ON
13. Check CLV ON
14. Auto Focus Offset Adjust
15. Auto Focus Gain Adjust
16. Auto Focus Offset Adjust
17. Eq Boost Adjust
18. Auto LFO Adjust
19. Auto Track Gain Adjust
20. 32Tj Fwd
21. 32Tj Rev
22. 500Tj Fwd
23. 500Tj Rev
24. All Servo Stop
8
1-5. DRIVE MANUAL OPERATION
[ENTER]
key, and the
On the Test Mode Menu screen, select
will be displayed. For the manual operation, each servo on/off
control and adjustment can be executed manually.
In using the manual operation menu, take care of the following
points. These commands do not provide protection, thus requiring
correct operation. The sector address or time code field is dis-
played when a disc is loaded.
Basic operation (controllable from front panel or remote com-
mander)
[RETURN]
[NEXT]
[1]
Cursor UP/DOWN
0. Disc Check Memory
## Drive Manual Operation ##
Operation Menu
1. Disc type
2. Servo Control
3. Track/Layer Jump
4. Manual Adjustment
5. Auto Adjustment
6. Memory Check
0. Disc Check Memory
Exit: Return
1. Set correctly the disc type to be used on the Disc Type
screen.
The disc type must be set after a disc was loaded.
The set disc type is cleared when the tray is opened.
2. After power ON, if the Drive Manual Operation was se-
lected, first perform "Reset SLED TILT" by opening 1.
Disc Type screen.
3. In case of an alarm, immediately press the x button to
stop the servo operation, and press the ?/1 button to
turn the power OFF.
?/1
Power OFF (release the Test Mode)
x
Servo stop
Z
Stop+Eject/Loading
Return to Operation Menu or Test Mode
Menu
[PREV]
,
Transition between sub modes of menu
[9]
[10/0]
to
,
Selection of menu items
Increase/Decrease in manually adjusted
value
Disc Check
1. SL Disc Check
2. CD Disc Check
3. DL Disc Check
0. Reset SLED TILT
[2]
, and the Operation Menu
Advertisement
Table of Contents
