Warranty - Haier HL32XK2 Owner's Manual

Specification
Product Specification
32"42"46"55"
Resolution
(Dot)
1920X1080
Power 120 V~ , 60 Hz
requirement
Color system NTSC, ATSC, Clear QAM
External 75 ohm
Antenna
Impedance
1,070,000,000 (1024 steps of each R,
Color
G and B)
Operating 32~104 °F (0~40 °C)
Temperature
Range
Operating Less than 80%
Humidity
Range
Maximum 6561 feet (2000 m)
Elevation
Dimensen (WXDXH) Unit:inches/
MODEL
mm (Including stand)
31.4X9.1 X22.6 inches
32"
798X230X575 mm
40.2X11.4 X28.5 inches
HL42XK2
1020X290X724 mm
HL42XZK22
40.2X11.4 X27.7 inches
1022X290X704 mm
HL42XZK42
44.1X11.0 X29.9 inches
46"
1122X280X760 mm
52.3X14.4 X35.2 inches
55"
1329X365X895 mm
Troubleshooting
Troubleshooting
For the sake of time and cost, it is strongly
recommended that you check out the problem by
yourself according to the instructions listed hereunder
before contacting the after-sales service for technical
assistance.
No picture,
no sound
HL32K2
Blank screen
1366x768
No sound
Poor sound
No picture
in some
channel
No color
for some
channel
program
Weight
(black and
(pounds/kg)
white)
24.1/11.0
Spots with
60.2/27.5
some or all
pictures
44.3/20.1
Horizontal/
48.5/22.0
vertical bars
or picture
shaking
86.0/39.0
Television
out of
control
Maintenance / Specification/Troubleshooting
Verify if the television is properly plugged.
Verify if the television is properly
supplied power.
Verify if electricity is available.
Verify if correct signals are input.
Press INPUT button to change signal
input to TV input.
Restart the television of power supply
is interrupted.
Press Mute button and verify if Mute
mode is set.
Switch to other channel and verify if
the same problem happens.
Press VOL+ button to see if the
problem can be solved.
Verify if sound system is correct. Refer
to Page 20 for adjustments.
Verify if correct channel is selected.
Adjust the antenna.
Make adjustments by Fine Tune and
Manual Scan.
Verify if the same problem exists in
other channels.
Check out of picture and sound
systems.
Refer to relative instructions in the
Manual for color adjust.
Verify if the antenna is correctly
connected.
Verify if the antenna is in good
condition.
Make fine adjustment of channel.
Check for local interference such as
an electrical appliance or power tool.
Disconnect the television from power
supply and, 10 seconds later, connect
the television to the power supply.
If the problem still exists, contact
authorized after-sales service for
technical assistance.
Note
Do not leave the television with static picture in
an extended period as the image may become
permanently burned.
Haier LCD HDTV EN-36