Battery Installation; Important Battery Information - LeapFrog My Pal Scout Smarty Paws Instruction Manual

BATTERY INSTALLATION

1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For
best performance, alkaline
batteries or fully charged Ni-
MH rechargeable batteries are
recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING
Adult assembly needed. Close the battery door and tighten
the screw to secure before giving your child the toy.
ATTENTION
L'assemblage doit être effectué par un adulte. Fermer puis
revisser fermement le couvercle du compartiment à piles
avant de donner ce jouet à un enfant.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
5