Table of Contents
Advertisement
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on
the back of the LCD Screen, use a
screwdriver to loosen the screw and
then open the battery cover.
3. Remove old batteries by pulling up on
one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries
following the diagram inside the
battery box. (For best performance, alkaline batteries or fully
charged Ni-MH rechargeable batteries are recommended.)
5. Replace the battery cover and tighten the screw to secure.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as recommended are
to be used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
RECHARGEABLE BATTERIES
•
Remove rechargeable batteries (if removable) from the toy before
charging.
•
Rechargeable batteries are only to be charged under adult
supervision.
•
Do not charge non-rechargeable batteries.
4
Advertisement
Table of Contents
