Table of Contents
Advertisement
Installation
I
NSTALLATION
H2TU-R-402
Wear an antistatic wrist strap when installing the H2TU-R. Avoid touching components on the
circuit board.
1
Align the H2TU-R with the enclosure slot guides and slide the unit in. Push the unit back until it touches the
backplane card-edge connector.
2
Place your thumbs on the front panel and push the H2TU-R into the card-edge connector.
When local power is applied to this unit, it automatically provides a resistive termination at its
HDSL2 port. This termination sinks 10 mA of sealing current when connected to a list 3E or
higher line unit.
6
Figure 3. Installing the H2TU-R-402 List 5E
March 12, 2001
LTPH-TP-1047-01, Issue 1
Remote enclosure
H2TU-R-402 List 5E
Advertisement
Table of Contents
