Jci1: Chassis Intrusion Connector; Jtpm1: Tpm Module Connector - MSI PRESTIGE X570 CREATION Quick Start Manual

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

JTPM1: TPM Module Connector

This connector is for TPM (Trusted Platform Module). Please refer to the TPM security
platform manual for more details and usages.
Downloaded from ManualsNet.com
Normal
(default)
1
3
5 LPC address & data pin0
7 LPC address & data pin1
9 LPC address & data pin2
11 LPC address & data pin3
13
search engine
Trigger the chassis
intrusion event
2 14
1
13
LPC Clock 2
LPC Reset 4
6
8
10
12
LPC Frame 14
Overview of Components
3V Standby power
3.3V Power
Serial IRQ
5V Power
No Pin
Ground
Ground
45