Advertisement
Datamate Power and M300 Crimp Contacts (when used with Positioner Z80-058):
M80-05500XX ................. Power Female crimp contact for 18-20 AWG
M300-0010045 ................ Power Female crimp contact for 18-20 AWG
M300-0020045 ................ Power Female crimp contact for 22 AWG
M300-1010045 ................ Power Male crimp contact for 18-20 AWG
M300-1020045 ................ Power Male crimp contact for 22 AWG
The hand crimp tool M22520/2-01 consists of a basic hand tool, which should be used with a
positioner.
The contact is correctly crimped when the tool is free to open at the fully closed position, i.e.,
when the ratchet releases. The tool cannot be opened without completing the cycle.
1.
Check that the tool is in the open position. Remove the safety clip from the positioner
guide (do not discard).
2.
Insert the Positioner into the positioner guide and turn it 90° in the direction shown on the
tool, until the bayonet pins lock.
3.
Install the safety clip back into the positioner guide (optional).
4.
Check Table 1 for the correct crimp tool setting of the wire size you wish to crimp.
5.
Remove the safety clip from the selector knob (do not discard).
6.
Lift and turn the selector knob until the correct crimp tool setting is lined up with the "Sel.
No." arrow. Lower the selector knob, ensuring the locating peg lines up with a notch.
7.
Install the safety clip back into the selector knob.
Harwin North America
T: +1 603 893 5376
E: mis@harwin.com W: www.harwin.com
IS-01
Issue: 9
Date: 27.04.2022
(used in M80-716 and M80-719 series).
GENERAL INFORMATION
TOOL PREPARATION
T: +44 (0) 23 9231 4545
E: mis@harwin.co.uk W: www.harwin.com
C/Order: 31490
Harwin Europe
Harwin Asia
T: +65 6 779 4909
E: mis@harwinasia.com W: www.harwin.com
Page 2 of 4
Advertisement
