Seat NAVI SYSTEM PLUS Owner's Manual page 9

›››
The right-hand rotary knob Fig. 1
setup button.
Infotainment buttons
The buttons on the unit are shown in this
manual with the words "Infotainment button"
and its function within a rectangle, for exam-
ple, Infotainment button.
MEDIA
The Infotainment buttons are used by press-
ing them or pressing and holding.
Switch on and switch off
To manually switch the Infotainment system
on and off, briefly press the rotary knob 
›››
Fig. 1 .
1
When switching on, the system starts-up with
the last set volume, provided that this does
not exceed the preset maximum start-up vol-
›››
ume page 72, Volume and sound
Depending on the unit and the country, the
infotainment system switches off automati-
cally when the engine is switched off or the
vehicle key is removed from the ignition. If
the Infotainment system is switched on
again, it will switch off automatically after ap-
proximately 30 minutes (switch-off delay).
Note
The Infotainment system is a part of the ve-
●
hicle. It cannot be used in any other vehicle.
Introduction
is the
4
If the battery has been disconnected, the
●
ignition must be activated before switching
on the Infotainment system.
Change base volume
Increasing or decreasing the volume or
muting the sound
Increasing the volume: Turn the volume con-
trol  clockwise or move the left thumbwheel
on the multifunction steering wheel upward
›››
Booklet Instruction

Lowering the volume: Turn the volume con-
trol  anti-clockwise or move the left thumb-
wheel on the multifunction steering wheel
›››
downward  Booklet Instruction
Changes in volume are indicated by a volume
bar on the screen. The volume can be control-
led using the steering wheel controls. In this
setup.
case, the changes in volume are represented
on the control screen by a volume bar.
It is possible to preset certain volume set-
tings and adjustments
and sound setup.
Muting the Infotainment system sound
Turn the volume control  anti-clockwise
●
until it displays .
Muting the Infotainment system sound stops
the media source that is playing The screen
displays .
If the base volume has been considerably in-
creased to play a certain audio source, lower
the volume again before switching to another
audio source.
Manual.
Manual.
›››
page 72, Volume
Note
7