Human Touch Perfect Chair PRO Use & Care Manual page 16

take
Adjust the recline angle
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently push the controller backward to recline the backrest, forward to incline the backrest, up to raise
the footrest, and down to lower the footrest. To automatically place the chair in zero gravity position,
press the controller inward and hold it until the chair stops moving (Fig.19).
NOTE: Lean back against the backrest before reclining the chair. Do not put any extra pressure on
the footrest while reclining, as this may prevent the footrest from properly deploying and locking.
OMNI-CONTROLLER
RECLINE the backrest
When adjusting the footrest up and down, you may notice
a slight bumping sensation. This is caused by the footrest
locking mechanism, and is perfectly normal.
humantouch.com
a seat
UP to raise footrest
DOWN to lower footrest
Fig.19
INWARD to move to zero gravity
INCLINE the backrest
Sensors located underneath each
armrest stop the chair from reclining
should anything become wedged
between the pad set and the armrest;
this is a safety feature.
14