LG PrintProof LTGL6937 Series Owner's Manual page 67

us_main.book.book Page 67 Friday, July 8, 2022 1:22 PM
Problem
Top burners do not Electrode area is not clean.
light or do not burn
• Remove the burners and clean them. Check the electrode area for burnt on food or grease.
evenly.
Burner parts are not installed properly.
• Make sure that the burner parts are installed correctly. See "Removing and Replacing the
Burners are not Burner heads and caps are not completely dry or properly positioned.
lighting properly
• Make sure that the burner heads and caps are completely dry and properly positioned.
after cleaning the
cooktop surface.
Burner flames are It may be due to improper installation or setting.
very large or yellow.
• If the range is connected to LP gas, contact the technician who installed your range or
Surface burners light Shut-off valve is not fully open.
but the oven does
• Make sure that the oven gas shut-off valve, located behind the range, is fully open.
not.
Food does not bake Oven controls improperly set.
or roast properly
• See the "Oven" section in the Operation chapter.
Rack position is incorrect or the rack is not level.
• See the "Oven" section in the Operation chapter.
Incorrect cookware or cookware of improper size being used.
• See the "Oven" section in the Operation chapter.
Oven thermostat needs to be adjusted.
• See the "Adjusting the Oven Thermostat" section in the Operation chapter.
The Clock is not set correctly.
• See "Changing Oven Settings" in the OPERATION chapter.
Aluminum foil used improperly in the oven.
• See "Using Oven Racks" in Oven section.
Food does not broil Oven controls improperly set.
properly
• Make sure you select the Broil mode properly.
Improper rack position being used.
• See the Broiling Guide.
Cookware not suited for broiling.
• Use broiling pan and grid.
The oven door is not closed.
• See "Broil" in the OPERATION chapter.
Aluminum foil used on the broiling pan and grid has not been fitted properly and slit as
recommended.
• See the "Oven" section in the Operation chapter.
Oven temperature Oven sensor needs to be adjusted.
too hot or too cold
• See the "Adjusting the Oven Thermostat" section in the Operation chapter.
Excessive smoking Excessive soil.
during a Self Clean
• Turn off the Self Clean function. Open the windows to rid the room of smoke. Wait until the
cycle (On some
models)
See "Cleaning Burner Heads/Caps" in the MAINTENANCE chapter.
Gas Surface Burners" in the MAINTENANCE chapter.
made the conversion.
Self Clean mode is cancelled. Wipe up the excess soil and reset the clean.
TROUBLESHOOTING
Possible Cause & Solution
67