Service Parts; Check Dual Handle Interlock; Check Fasteners; Check Clutch Cable Adjustments - Ariens Sno-Thro Professional Series Operator's Manual

SERVICE PARTS

See your Ariens dealer to purchase service
parts for your unit.
Description
Ariens Hi-Temp Grease
• 97 ml (3 oz) cartridges (3)
• 414 ml (14 oz) cartridge (1)
Ariens L3 Lube – 237 ml (8 oz) 00068800
Shear Bolt and Nut
Fuel Stabilizer – 118 ml
(4 oz)
• Except Canada
• For Canada Only
Gearcase Seal Washer
20 Watt Headlight Bulb
Spark Plug
Ariens 5W-30 Engine Oil
• 473 ml (16 oz)
• 946 ml (32 oz)
Fuse – 5 Amp (Battery)
Fuse – 7.5 Amp
(Handwarmers & Headlight)
CHECK DUAL HANDLE
INTERLOCK
1. Stop engine.
2. Engage attachment clutch and then the
traction drive clutch.
3. Release the attachment clutch lever. The
attachment clutch should stay engaged
until the traction drive clutch lever is
released.
IMPORTANT: If dual handle interlock does
not operate correctly, repair as directed in the
service guide for your unit.

CHECK FASTENERS

Check for loose hardware.
CHECK CLUTCH CABLE
ADJUSTMENTS
Auger / impeller must stop within 5 seconds
when attachment clutch lever is released.
Wheels must stop quickly when traction drive
clutch lever is released.
If clutches do not engage or disengage
correctly, see Adjust Attachment Clutch &
Brake on page 19 or Adjust Traction Drive
Clutch on page 21. Refer to the service guide
for your unit for more information about clutch
repairs.

CHECK TIRE PRESSURE

Keep tires inflated to pressure listed on tire
sidewall.
Part No.
00036800
00036700
52100100
04730400
04742500
06400920
00432600
20001246
00091000

CHECK ENGINE OIL

00067600
NOTICE: Engine oil level must be maintained
05076400
at correct level or engine damage may occur.
04954200
Refer to engine manual.

CHANGE ENGINE OIL

Refer to engine manual.

CHECK AUGER GEARCASE OIL

1. Place unit on flat, level surface.
2. Remove oil fill plug and seal washer. See
IMPORTANT: DO NOT remove gearcase
cover.
1. Auger Gearcase Cover
2. Oil Fill Plug
3. Seal Washer
EN - 14
WARNING: AVOID INJURY.
Explosive separation of tire and
rim parts is possible.
• DO NOT inflate tires above
the recommended pressure.
• DO NOT inflate tires with a
compressor; use a hand
pump.
• DO NOT stand in front of tire
assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you
to stand to one side.
• DO NOT mount a tire without
proper equipment and
experience.
Figure 16.
2
1
Figure 16
3