Using The Clipper; Care - Panasonic ER-GP30 Operating Instructions Manual

• You can charge the battery before it is completely discharged.
However, it is recommended to charge when the battery is
completely discharged. The battery life depends strongly on
factors such as how it is used and stored.
AC operation
If you connect the AC adaptor to the clipper in the same way as for
charging, and turn on the power, you can use it.
• If the remaining battery is too low, the blades may move slowly or
stop, even with the AC operation. In this case, charge the battery
for 3 minutes or more.
• The battery will be discharged, even with the AC operation.

Using the clipper

• Make sure that the clipper is turned off.
• The appliance may not operate in an ambient temperature lower
than approximately 0 °C.
1
1
Select the trimming heights indicated on the
insides and sides of the attachments.
2
2
Slide the power switch on the main body to the
" " position to turn on the clipper.
Removing and mounting the comb attachments
Mounting the attachment
Align the front of the attachment
with the blade (A), and then
press the attachment against the
main body (B).


Removing the attachment
Slide one side of the attachment off the
mounting in direction indicated with the
arrow.

Care

Removing and mounting the blade
• Make sure that the clipper is turned off.
Removing the blade
Hold the clipper with the switch facing
upward and push the blade with your thumb
while catching the blade in your other hand.
Mounting the blade
Fit the mounting hook into the blade mounting on the clipper and
push in until it clicks.
9