Safety 1st Grow and Go Extend N Ride Manual page 11

15
8
If the car seat
moves more than 1 in.
(2.5 cm), you can try:
• Pulling the belt
tighter; OR
• Reinstalling the car
seat; OR
• Changing to a
Check Belt Tightness
different seating
location; OR
Hold the Rear-Facing Belt
Path with your non-dominant • Switching to a
hand. Push and pull the car different install
seat from side to side.
method (LATCH or
vehicle belt).
It should not move more than
1 in. (2.5 cm).
9
Adjust Footrest
Use one of the 3 Rear-Facing footrest positions to put
the footrest as fl ush against the vehicle seat as possible.
The footrest does not need to touch the back of the
vehicle seat; there can be a small gap.
10
Rear-Facing Mode
Footrest Use
1A
1B
Secure Child in
Car Seat
1C
See page 29-31.
For more information
about using the
footrest, see page 49.
11
Only if necessary, you
may place a tightly
rolled towel(s) or foam
pool noodle(s) under
the front of the car seat
base to help make the
Recheck Rear-
Rear-Facing Level
Facing Level Line
Line parallel with the
Redo the installation ground.
if the car seat is not
Check often to make
reclined correctly for
sure padding is still in
your child.
place and the belt is
tight.
continued on next page
16