Advertisement
KD-LH70R
QQ
2.1.5 Removing the rear bracket
3 7 63 1515 0
(See Fig.8)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink and bottom
cover.
(1) Remove the three screws E, two screws F and two screws
G on the back side of the main body.
(2) Remove the rear bracket.
REFERENCE:
During reassembly, before fixing the rear bracket onto the
main body, insert the Subwoofer and steering cables into the
slots.
2.1.6 Removing the main board
(See Fig.9)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover and rear bracket
(1) Remove the two screws H attaching the main board.
(2) Disconnect the connector CN101 and remove the main
board.
TE
L 13942296513
2.1.7 Removing the mecha control board
(See Fig. 10)
• Prior to performing the following procedure, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover, rear bracket and main board.
(1) Remove the five screws J attaching the mecha control
board.
(2) Disconnect the card wire from the mecha connector.
(3) Move the mecha control board in the direction of the arrow
to release it from the joint g.
www
1-6 (No.49803)
http://www.xiaoyu163.com
x
ao
y
.
i
http://www.xiaoyu163.com
8
Rear bracket
E
CN101
H
Q Q
3
6 7
1 3
Joint g
Mecha
connector
Card wire
Mecha control board
u163
.
2 9
9 4
2 8
G
F
G
E
Insert Subwoofer and steering
cables into the slots.
Fig.8
Main board
1 5
0 5
8
2 9
9 4
Fig.9
J
m
Top chassis
co
J
Fig.10
9 9
H
2 8
9 9
Advertisement
