Haier HWS247GGU1 User Manual page 20

Installation
Assembly steps
1. Provide necessary tool.
2. Unplug the appliance.
Remove the upper beam cover and small cover,
3.
Left and right transposition installation of small cover.
4. Remove the cable tray cover and trim cover, Left
and right transposition installation of decorative
cover.Remove the black rubber plug from the left
Keyhole on the inside of the door body and install
it on the right keyhole.
5. Remove hinge cover,Use the tool to remove 3
screws and remove the portal body .
6. Remove the 3 screws under the portal body with
the tool,portal body cam and door stop,
the left and right transposition is installed on the
other side of the portal body .
7. Remove the box hinge assembly with the tool,
assembly,replace the hinge shaft to the right
screw hole,assembly.Transposition installation
with the caster support assembly on the right side
of the box.
8. The portal body is installed vertically downward
on the hinge shaft.
The upper hinge is inserted into the shaft hole
9.
the wire box cover and the upper beam trim cover.
18
EN
2
1
3
4
5
6
6.1
7
7.1
8
9