HP HPE FlexNetwork 7500 Quick Start Manual

Manual Version: 6P101-20160216
HPE FlexNetwork 7500 48-port 1000BASE-T SE
Module - LSQM1GT48SE0 (JH212A, JH220A)
1 Card identifier
The card identifier LSQM1GT48SE0 is at the upper right of the front panel.
2 Specifications
IMPORTANT:
Before installing the card, you must remove the protection cover from the card.
Table 1 Card specifications
Item
Card size (H × W × D)
Power consumption
Net weight
Connector type
Ports
Port rate
Transmission medium and max
transmission distance
Applicable hardware platforms
NOTE:
To verify compatibility of the card with the software release you are using, see the release notes.
The 10/100/1000BASE-T copper port uses an RJ-45 connector.
Figure 1 RJ-45 connector
PIN #8
PIN #1
BOM: 3123A17N
Specifications
40 × 399 × 352 mm (1.57 × 15.71 × 13.86 in)
38 W to 48 W
3.18 kg (7.011 lb)
RJ-45
48
10/100/1000 Mbps
NOTE:
The 10/100/1000BASE-T copper ports do not support half-duplex
configuration or autonegotiation.
100 m (328.08 ft) over Category 5 or higher twisted pair cables
All 7500 models.
1
Part number: 5998-7205R