Diplomat ADP8352 User Manual page 4

INSTALLATION - ELECTRICAL CONNECTIONS
WARNING: THIS APPLIANCE MUST BE EARTHED
Fuse Replacement
If the mains lead of this appliance is fitted with a BS1363A 13 amp
fused plug, to change the fuse use an A.S.T.A. approved fuse to
BS1362 and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit a replacement 13 amp fuse into the fuse cover.
3. Refit the cover and fuse into the plug.
Important:
The fuse cover must be refitted when changing a fuse. If the fuse cover is lost the plug
must not be used until a replacement cover has been obtained. Replacement fuse covers
are available from your local electrical store.
If the plug supplied is not to be used please cut the
mains cable and dispose of the plug safely. Your
appliance must then be connected to fixed wiring
via the use of a double pole switched fused spur
outlet with at least 3mm contact separation, with a
pilot lamp. (See technical data for fuse rating). We
strongly recommend the appliance is connected by
a qualified electrician who is a member of the
N.I.C.E.I.C or Corgi who will comply with the I.E.E
and any local regulations.
NOTE:
The terminology ''DOUBLE POLE'' means that
both the live and neutral supplies are switched
and disconnected at the same time.
The terminations labelled SUPPLY are for the
connection for the internal house wiring and the
terminations labelled LOAD are for connection
for the appliance.
IMPORTANT
The wires in this mains lead are coloured in accordance
with the following code:-
Green / Yellow Earth
Blue Neutral
Brown Live
As the colours of the wires in the mains lead of this appliance
may not correspond with the coloured markings identifying the
terminals in your spur box, proceed as follows;
The wire which is coloured green and yellow must be connected
to the terminal which is marked with the letter 'E' or by the earth
symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the
terminal which is marked with the letter 'N' or coloured black.
The wire which is coloured brown must be connected to the
terminal which is marked with the letter 'L' or coloured red.
2
ON
FUSE
BLUE BROWN
(NEUTRAL)
(LIVE)
L
LOAD
L
N
SUPPLY
LOAD
DP
13A 250V~
N
SUPPLY
GREEN & YELLOW
(EARTH)
FUSE RATING:
13 AMP
Cleaning and Maintenance (cont.)
Cleaning the Spray Arms
The spray arms can be easily removed for periodic cleaning of the nozzles, to
prevent possible clogging. Wash them under running water and carefully replace
them in their positions, checking that they rotate freely.
To remove the upper spray arm, unscrew locking ring R.
To remove the lower spray arm, simply lift it up, pulling by the central part.
15