Haier YR-E06 Operation Manual

Installating the wire controller
1. Remove upper cover of wire controller
Remove upper part of wire controller by press.
PCB is mounted on lower part of wire
controller, be careful not to damage it.
2. Install the wired remote controller
Please drill two holes on the wall according to the
back cover screw hole position of the wire remote
controller, then strike the wood block to the holes
respectively, then align the 2 screw hole of the wire
controller back cover to the wood block, fasten the
wire reote controller to the wall use wood screws.
3. Switch setting
The switchs setting as follows:1.ON 2.OFF 3.ON 4.OFF
Note
Try as far as possible a flat surface for installation.
Don't use excessive force when tightening screws,
or lower part might got deformed.
4. Connecting method as the following chart
contents
No Symbol colour
1 A
White or Green 12V
2 B Red
Gnd
3 C
Yellow
COM
4 D
Use shielede wires for telecommunication
between wire controller and indoor unit;
indoor unit and outdoor unit. Ground the
shield on one side.
Otherwise misoperation because of noise
may occur.
Signal wire is self-provided by user.
5. Replace the upper cover of wire controller
Be careful not to hold down the wiring.
Hint 1. Power supply switch and signal wire should be prepaired by the user.
2. Don't touch PCB with hand.
Upper cover of wire
controller
Lower cover of wire
controller
Switch button
Screw hole
Back cover of the wire
controller
Shielded wire
ground
11
OPERATION MANUAL
YR-E06&YR-H71
Table of Contents
Parts and Functions
Operation
Health Function and Installating the Reciever
Installating the wire controller
No. 0010573682
C
Please read this operation manual before using the air conditioner.
Please keep this manual carefully and safely.
1-4
5-9
10
11