Advertisement
Replacing filter
It is recommended to replace the True
HEPA filter every 6 months.
1. Remove cover by using rib and lift off.
2. Insert the new True HEPA filter. Make
sure ribbon tab is exposed and the filter
is pushed in completely to ensure the
unit operates properly.
The filter indicator on the control panel will turn on in red and flash when it's time to replace
your filters. For the best performance, replace the True HEPA Filter every 6 months.
Visit www.sunbeam.com.au to see which retailers sell our genuine Sunbeam
SAPF0800 True HEPA filter replacements.
6
3. Realign the cover and gently press it
back into the unit.
4. Turn the power ON.
5. To reset filter reminder, press and hold
the Fan Speed Button for 3 seconds,
the red flashing indicator will then turn
off.
Troubleshooting
For troubleshooting and FAQs visit www.sunbeam.com.au.
Problem
Solution
Why is my unit not
Make sure unit is turned ON.
working?
Make sure filter is properly installed and the filter door is correctly
closed.
Use USB cord to input 5 VDC 1.0A for battery charging.
Why is there a
Make sure nothing is blocking air intake grille and filtered air outlet.
decrease in air
Check condition of the filter and replace if necessary.
flow?
Check filter to remove any plastic wrapping/packaging.
Use USB cord to input 5VDC 1.0A for battery charging.
Why is the unit
Make sure parts are firmly positioned in place.
making a loud
Open the filter door and verify that any plastic packaging was
noise?
removed from the filter.
7
Advertisement
