Advertisement
3.WATER SUPPLY KEY
(1) This key is valid except for error cases.
(2) This key-in changed the mode as follows.
Cold Water → Hot/Cold Water → Hot Water
(3) If you select a water supply by using the water supply key, the selected water supply setting remains valid
even if you changed a course after. If you switch to the wool course, cold water is automatically selected, but
the previous setting is restored if you switch to the other course.
(4) Error cases as follows in above item (1).
- Water supply error
- Drain error
- Water sensing error
- Door error
(5) While water is being supplied the corresponding water supply lamp flashes on/off by 1 sec. interval.
(6) In COLD/HOT WATER mode, cold water is supplied together with hot water in the first cleansing step,
and from second cleansing step, only cold water is supplied.
4.START/PAUSE KEY
(1) This key-in toggles between start and pause as follows.
Start → Pause
(2) Pause displays the remaining 1 sec. on/off.
(3) This key performs error clear function.
- Water supply error
- Drain error
(4) Delay time to re-start after pause mode is as follows.
START MODE
DRIVING PART
Water Supply Valve
WATER SUPPLY
Rinse Valve
WASH
DRAIN/PAUSE
SPIN (including
intermittent spin)
5.WATER LEVEL KEY
(1) The Water Level key is always valid except for Error cases.
* Error: Water Level Sensor, Water Supply Error, Drain Error, Door Error, Unbalance Error
(2) Pressing the Water Level key shows the options in the order as below.
Middle → High → Lowest → Extra-Low → Low
(3) If Blanket course is selected, only middle water level or above is available.
(4) If Wool course is selected, only Low water level or above is available.
(5) When you selected a water level, pressed pause key and changed a course to Blanket or wool, the blanket
course is automatically set to high level if the water level is under middle level but it remains the previous
setting if the water level is middle level or above and the wool course is automatically set to high level if the
water level is under low but it remains the previous setting if the water level is low.
START FUNCTION PAUSE FUNCTION START FUNCTION
Motor
Mr.ML
Drain
Motor
Drain
Motor
Motor
(ML)
2sec.
2sec.
2sec.
2sec.
2sec.
4
REMARK
Delay times is 10
sec. dispersing 1
after UNB is detected.
Advertisement
