Advertisement
6-3 Replacement of CLUTCH ASS`Y
1) After removing CONTROL-PANEL
2) Remove COVER-SCREW 2EA(R · L) in CONTROL-PANEL
by using a pin and remove a SCREW 2EA(R · L) securing
CONTROL-PANEL by using a (+) driver and then remove
CONTROL-PANEL by pushing it slightly to left.
3) Remove screws (2EA in rear, 2EA in front) securing
TOP-COVER and remove SCREW securing EARTH
IRE and then lift TOP-COVER ASS`Y backward.
4) Remove 4 screws securing COVER-TUB and take
COVER-TUB out.
5) Remove PULSATOR-CAP by using a pin. After inserting
the (-) driver between the PULSATOR-CAP + PULSATOR,
disassemble by pushing it upward( ↑ ).
※ Fix in the groove of ① and assemble by pushing ② .
6) Remove a bolt securing the PULSATOR using 10mm box
and lift it up.
7) Remove a nut securing ASS`Y SPIN BASKET and CLUTCH
by using a ZIG box and take ASS`Y SPIN BASKET out.
※ NUT unlock : clockwise
NUT lock : counter-clockwise
8) Lay down the washing machine so that the front of
OUT-CASE faces upward and remove 4 bolts securing
SADDLE by using a 10mm box.
※ Be careful not to cause damage or scratch to the washing
machine when you lay it down to the floor.
9) Remove BOLT 4EA securing CLUTCH by using a 10mm box
and take CLUTCH-ASS`Y out. (Check the CLUTCH status as
shown in the figure here.)
※ Assembling is in reverse order as disassembling.
Points to check after replacing ASS`Y CLUTCH
1) Check if TOOTH is joined by 3.5mm ∼ 5.5mm, 2.0mm ∼ 4.5mm
depth to the blades of SLEEVE while the washing is in operation.
(with Drain Motor OFF)
※ If the joining depth is not deep enough, there may be a problem
during washing.
2) Check if TOUCH maintains at least 1.5mm distance from the edge
of SLEEVE during spinning. (with Drain Motor OFF)
SADDLE
3.5~5.5mm(ENGAGING DISTANCE)
(The Condition During Washing)
OVER 1.0mm(ENGAGING DISTANCE)
25
SADDLE
CLUTCH
MOTOR
(The Condition During Spining)
Advertisement
