Advertisement
2-5 TEST PROGRAM MODE
2-5-1 TEST MODE FUNCTION (Drive and other test)
1) How to enter: (Water level + Course +Power s/w)
2) MODEL change: you may change mode by pressing COURSE key in test mode.
3) Mode discription
MODE NO. DISPLAY
1
"01"
2
"02"
3
"03"
4
"04"
5
"05"
6
"06"
7
"07"
"08"
"OE"
8
AGING TEST FOR DRIVING Drive and Display turn ON/OFF
as follows. SPIN LAMP (DRAIN/MOTOR) Cold water. Hot
water SPIN LAMP (RINSE) "r" 7-SEG (MOTOR RIGHT) "L"
SPIN AGING MODE
After detecting reset in 50 sec. it proceeds starting
intermittent spin in 3rd times and then continues spin course
in the order of 5 min. ON and 3 min. OFF.
If the initial water level is under reset it starts intermittent
spin after 20 sec.
- Door error or unbalance error will be detected and
displayed as follows.
Door error : "dE" UNBALANCE ERROR : "UE"
It is selected under the condition of high water level set (Hot
water/Cold water) and motor starts rotating repeatedly after
supplying high water level.
Water level sensor is marked by HEX-DECIMAL VALUE in
water level frequency.
Weight sensor is marked by HEX-DECIMAL VALUE as med.
low, extra low when pressing the water level key.
Weight sensing test/value indicate mode Start key-in performs
weight sensing and total pulse number displays after
selecting water level. It is marked on the 7-SEGMENT under
100, SPIN LAMP turns ON over 100 and RINSE AND SPIN
LAMP turn ON over 200.
TEST MODE OF WATER SUPPLY VALUE cold water for
RINSE VALUE turns ON/OFF by 2 sec. REPEATED MODE
Med. low, extra low A/D PORT OPEN/SHORT PIN NO DISPLAY
OVER FLOW ERROR FUNCTION
It performs the release function during in operation which
drains overflow water level to selected water level by 2 times
and performs overflow error function in 3rd times when over
error happens keeping motor going on until power OFF
TEST CONTENT
9
REMARKS
Open and close
door, and you
may run
dehydration after
UNB.
Advertisement
