Dry Operation - Haier HSU-10HM03 Operation Manual

Operation

Dry Operation

Remote controller
COOL operation starts when room
temp.is higher than temp.setting.
o
Temp.setting+2 C
Temp.setting
On reaching temp.setting +2
unit will run in mild DRY mode.
1. Unit start
Press ON/OFF on the remote controller, unit starts.
2.Select operation mode
Press MODE button. For each press, operation mode
changes as follows:
Remote controller:
Then Select DRY operation
3.Select temp.setting
Press TEMP. button
Every time the button is pressed, temp.setting
increase 1 C,if kept depressed, it will increase
rapidly
Every time the button is pressed, temp.setting
increase 1 C,if kept depressed, it will decrease
rapidly
Select a desired temperature.
4.Fan speed selection
Press FAN button. For each press, fan speed changes as
follows:
Remote controller:
Air conditioner is running under dispalyed wind speed.
In DRY mode, when room temperature becomes 2
higher than temp.setting,unit will run intermittently at
LOW speed regardless of FAN setting.
5.Unit stop
Ultra-low air flow
Press ON/OFF button, the unit stops.
o
C
AUTO COOL
LOW
MED
11
DRY FAN HEAT
HI AUT
O
O
C