Pioneer SPH-EVO64DAB-208 Operation Manual page 110

Rds av receiver
Hide thumbs Also See for SPH-EVO64DAB-208:
Table of Contents

Advertisement

HUB Error
→ The connected USB hub is not
supported by this product.
– Directly connect the USB storage
device to this product.
No Response
→ This product cannot recognise the
connected USB storage device.
– Disconnect the device and replace it
with another USB storage device.
→ The USB connector or USB cable has
short-circuited.
– Check that the USB connector or USB
cable is not caught in something or
damaged.
→ The connected USB storage device
consumes more than maximum
allowable current.
– Disconnect the USB storage device
and do not use it. Turn the ignition
switch to OFF, then to ACC or ON and
then connect a compliant USB storage
device.
→ The USB interface cable for iPhone has
short-circuited.
– Confirm that the USB interface cable
for iPhone or USB cable is not caught
in something or damaged.
Your device is not authorized to play this
DivX protected video.
→ This product cannot play copy-
protected DivX files.
– Select a file that can be played.
Audio Format not supported
→ This type of file is not supported on this
product.
– Select a file that can be played.
iPhone
There was a problem communicating
with your iPhone. Please reconnect.
→ iPhone failure.
– Disconnect the cable from the iPhone.
Once the iPhone's main menu is
displayed, reconnect the iPhone and
reset it.
→ The iPhone firmware version is old.
– Update the iPhone version.
Apple CarPlay
Connection failed.
→ Communication failed and the system is
trying to connect.
→ Wait for a while. Then, perform the
actions below if the error message is still
displayed.
– Restart the iPhone.
– Disconnect the cable from the iPhone,
and then connect the iPhone again
after a few seconds.
– Turn the ignition switch to OFF and
then to ON.
Please attach the GPS antenna in order to
use Apple CarPlay over Wireless.
→ This unit cannot properly detect the
GPS signal from the GPS aerial.
– Check the GPS aerial installation and
connection. For details about the
connection and installation, refer to
the Installation Manual.
The speed sensor is disconnected. Please
attach it.
→ The speed sensor cannot detect any
signal.
– Check the speed signal cable
connection. For details about the
connection, refer to the Installation
Manual.
Please attach the GPS antenna and the
speed sensor in order to use Apple
CarPlay over Wireless.
→ This unit cannot detect the GPS signal
from the GPS aerial and the speed
signal from the speed sensor.
- 110 -

Advertisement

Table of Contents
loading

Table of Contents