Contact Information; Don't Forget To Register; Limited Warranty - Brother P-touch PT-D460BT Manual

Hide thumbs Also See for P-touch PT-D460BT:

User manual (120 pages)

Quick start manual (9 pages)

Table Of Contents

Table of Contents

Problem

Solution

The ink ribbon is separated

If the ink ribbon is broken, replace the Tape Cassette.

from the ink roller.

If it is not, leave the tape uncut and carefully remove

the Tape Cassette, and then wind the loose ink ribbon

back onto the spool.

Printed barcodes or QR

• Change the tape. (Recommended: Black on white tape)

codes cannot be read.

• Enlarge the barcodes or QR codes using the barcode application,

if possible.

I do not know the firmware

Confirm the firmware version by pressing the following keys:

version of the Label Maker.

When the label is printed,

• Refer to the Set Margins section in this guide and select [Small

there is too much margin

Margin] [Chain] or [No Cut] for smaller margins.

(space) on both sides of the

When you set [Small Margin], the label maker feeds approx. 0.9"

text.

(23 mm) of leader tape before every new label.

To save tape, set the [Chain] setting. After the last label prints, press

and

• The Label Maker feeds approx. 0.9" (23 mm) of tape before every new

label. When printing multiple labels, you can reduce the blank space

on the second and subsequent labels.

Select the [Chain] setting in the optional print settings. Then, print your

labels and leave the last label in the Label Maker until you are ready

to print a new label.

• After the last label prints, press

the tape, and then eject and cut the last label. Note that the Label

Maker will feed approx. 0.9" (23 mm) of tape before the next new label

when you use this method.

The font size cannot be

The font is already the maximum size for the width of the label. Or, the

increased.

label length has been set, so there is a limit on the font size to prevent

exceeding the set length.

When multiple labels are

When Chain Print is enabled, feed the tape to eject the last printed

printed, the last label is cut

label, and then press the Tape Cutter Lever to cut the label manually.

incorrectly.

[Settings]

[Version Information]

to feed the tape, and then press the Tape Cutter Lever.

and

simultaneously to feed

Troubleshooting (cont.)

Problem

Spool

I cannot update the printer's

firmware using the P-touch

Update Software, Transfer

Express, or Mac Update

Tool.