Install The Etrust Agent For Cisco Nac; Verify The Installation - Computer Associates G01028-1E Installation Manual

Install the eTrust Agent for Cisco NAC

Verify the Installation

Install the eTrust Agent for Cisco NAC on all end-point devices, such as desktop
computers, workstations, laptops, and servers that connect to or use network
resources.
To install the eTrust Agent for Cisco NAC on an end-point device, follow these
steps:
1. From the directory you downloaded the eTrust Agent for Cisco NAC,
distribute CAPPInstall.exe to all end-point devices.
2. Run the following command to silently install the eTrust Agent for NAC on
the end-point device:
CAPPInstall.exe -silent
The files cai-pp.dll and cai-pp.inf are installed in
%CommonProgramFiles%\Cisco
Systems\CiscoTrustAgent\Plugins\Install. The next time the Cisco Trust
Agent runs, these files are automatically moved up one directory level to
\Plugins.
Use Cisco Secure ACS to verify that the Computer Associates attributes have
been installed. For instructions, refer to the Cisco document NAC User Guide for
Cisco Secure ACS 3.3.
To verify the installation of the eTrust Agent for Cisco NAC on an individual
end-point device, restart the device and check that the following files exist in
%CommonProgramFiles%\Cisco Systems\Cisco TrustAgent\Plugins:
cai-pp.dll
cai-pp.inf
For further assistance, see the Computer Associates SupportConnect website at
http://supportconnect.ca.com, where you may check the Knowledge Base for
additional information or contact a Customer Support representative.
Install the eTrust Agent for Cisco NAC
Setting Up eTrust Agent for Cisco NAC 11